01-12-2004, 08:29 PM
|
 |
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
How to upgrade motor wires using stock connectors
Last edited by jon.jon; 01-12-2004 at 09:09 PM.
|
01-12-2004, 08:30 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
There is two grooves in the holes with the male pin
|
01-12-2004, 08:35 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
What yoy need to do next is find something small to fit into grooves with the male pines(I used the metal spring thing that holds the magnet in place inside the motor).
|
01-12-2004, 08:42 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
The odject is to get something in there to press the Tiny tabs down on the male pins .doing this will allow you to pull the wires out the housing
|
01-12-2004, 08:47 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
Once you get wire out pry open the clips that holds the insulated part of the wire. pull the wire out of the clips and cut wire
|
01-12-2004, 08:50 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
prepare new wires. place wire in male connector. close clips then solder
|
01-12-2004, 08:56 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
Remember to pull the Tiny tabs back up so the pin can lock once its back in and also when placing the pin back in the housing the pin goes in where the tabs sticks upward and the groove in the housing fits.
|
01-12-2004, 09:07 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
|
Car female connector . On the female housing press the Tiny tabs down and pull the wire out the housing.Repeat male connector procedure for installing wire and placing back in housing
Note: Mark pos+ and neg- on housing so you know where wires go. Need any more details let me know.
|
01-13-2004, 10:47 AM
|
 |
Moderator
|
|
Join Date: Jan 2003
Location: Richmond, VA.
Posts: 2,732
|
|
|
Nice work jon.jon. I'm gonna make a link to this in the Tips and Mods sticky.
|
01-13-2004, 01:44 PM
|
|
.
|
|
Join Date: Nov 2003
Location: Va
Posts: 188
|
|
I was hoping it would be helpful information. Thanks. 
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -5. The time now is 10:15 AM.
|
|
Linear Mode
