pcb flip (how)

[kyle_9013]

how do you do a pcb flip i need a picture so i can see where the steering wires go.

[Demon666]

sorry i dont have a pic but ill try to explain it to you. take a left and a right sterring wire and solder them to the posotive on the pcb the + is were the red wire is and then take the left over right and left wires and put them in the L and R posistiion on the pcb. be sure before you solder any of the sterring wires you take the clear coat off the wire you can do this with a lighter or match but be carfull not to hold the flame to the wire for too long.

[kyle_9013]

thanks but why do you have to take the clear coat off and is this on a zipzap

[Demon666]

i cant tell you exatly why you have to take it off i only know if you dont remove it from the wire were its gonna be solderd it wont make a conection. and all micro rc's have clear coat on them. maybe they put it there becouse if they didnt have it it would get interferance from the other wires in the chassis.