|
The reason you xmod steering may jump back and forth is because of the sterring play. When your car is assembled look at the front nuckle with the tie rod in it. It has plenty of room to move back and forth and side to side. You can fix this by using about an half an inch of tephlone tape. Then wrap a 1 and a half inch piece around each end of your tie rod. This should fix your wobling. And give the tape a little while to break in.
The 4.5 is good for sharp turns.
The 4 is good for wider turns.
The 3 is good for straight stretches.
And the suspension will also help your car because you can use diffrent hardnesses and softnesses to make your car perform better on certian surfaces.
__________________
350z-SS 130 motor, bearings cf driveshaft, custom paint,
------------------------------------------------
supra- high torque 180, 6 cell bearings,
------------------------------------------------
civic- powerdash, bearings,cf driveshaft
------------------------------------------------
rsx-fried
4supras fried
2 skylines detroyed
1 civic destroyee
Last edited by 10_second_supra; 12-28-2003 at 05:16 PM.
|