Yet Another speed Mod

[DraGula]

This mod is very easy, but requires the use of a soldering iron.
1. desolder or rip off where shown.
2. connect the two points left after the part is removed.
3. charge and watch it go!!!
the boost of speed from this mod is minor, but i havent found any downside to doing this though.
(thanks to namuna for the use of the pic!!)

[Tazzy]

I've got a shen qi wei with a PCB that looks the same but I don't have the fancy text nor the black blob... should I go ahead with this mod?

[BabyKiller]

and what does this do take off a resistor to allow more voltage to the motor in other terms a simple semi mosfet?

[FoeverClownin]

do u have a version for the big lots thunder charger clone

[DraGula]

i didnt test the voltage output yet, it should be higher, and this will probably work on clones, it will do the same thing to their electronics.

[RobotGT]

would one glob of solder connecting the 2 points work. im really concidering trying this! good pic and directions

[DraGula]

of course one glob of solder would work, you just need to connect the points.

[Clownn]

i just finished doing it put i did not connect the two points and it still worked do i have to connect the two points so it can work good??

[Clownn]

i just took it for aride ant the reception is the worst it wont even go 2 feet

[DraGula]

that's strange, i didn't notice any range loss when i did this.

[Clownn]

i had to go exchange it for a new one in target

put of course striped it compleatly