2 cell mod

Go0ty · #1 02-01-2003, 02:17 PM

is it possible to do a 2-cell mod without performing any soldering? if so, would it work just as good without a soldering job? i dont have a solder iron but i'd like to try a 2-cell mod

isk8blind · #2 02-01-2003, 02:29 PM

yah you dont need to solder just hook up the wires in the little metal tab by the batterie and tape the other sides to the other batterie

Go0ty · #3 02-01-2003, 03:49 PM

any place i can get a diagram for something like this?

zclonedude · #4 02-01-2003, 05:38 PM

http://tinyrc.com/qfm/racing/mod_07.htm#25
this might help u might be able to use tape insted of solder.

drft240 · #5 02-02-2003, 02:44 PM

hey man look up the laymens battery mod it takes no solder and you can even do 3 batts if you want. good luck

Go0ty · #6 02-02-2003, 04:41 PM

i tried to find the link but it was in one of the other posts and it was a dead link or something so.. any mirrors on it or anything?

sessiz10 · #7 02-02-2003, 06:49 PM

I highly recomend the layman's mod. You can find the thread in the bit science forum. Here's a link
http://www.tinyrc.com/forums/showthr...&threadid=6045

Go0ty · #8 02-02-2003, 07:17 PM

that mod looks pretty cool but ih ave a question, if I use the 2 stock ZZ batteries and it works right, will I have to mod my controller to charge the batteries differently or will I Just have to charge multiple times? making a charger sounds even more complicated than modding the car for 2-cell.