binding problem
 

the son and i just put a rat shack bearing kit in his nsx and now the car will hardly move. any tips or hints would be accepted. Thanks

Remove the motor and check how the driveline spins, does it bind up? If the center shaft is not seated right it will put the whole driveline into a bind. Turn each wheel and see how it feels, trial and error will get you there:D

hmm, my NSX didn't have any trouble with the AWD, but the bearings wouldn't go on the axle all the way so i have 2 left-over bearings taht wouldn't go on.

You most likely put the wheel lugs on too tight. This is a common mistake, so don't feel too bad if it's the problem.