I'm done with this thing. It managed to pull the threads out of the rear frame (nothing to do with the cf but rather the crappy RS plastic). It's extremely fun and will make you giggle like a schoolgirl when it works. It has a Mini-X servo and receiver, Mamba 6800 motor and Mamba 25 ESC, 3 kokam 340s (no charger included), full aluminum drivetrain (Atomic Mods cups and GPM dogs). It is RWD with a cusom short driveshaft. The radio's a Futaba 2PL. I'll throw in some Z foams mounted on 11mm wide CLK-DTM rims with xmod adapters for the rear and a set of 5 spokes along with Kyosho lugs. Everything sits in a Tiny RC's Zero CF frame. It has aluminum knuckles. The Mamba's bolted down via a modded plastic heatsink with custom spacers and a 1.09:1 gear ratio (white bevel turned into a pinion w/ setscrew).There's no body, but if the one I was planning on shows up sometime, I'll throw it in (Chevy Cheetah body). Red springs with a swaybar in the back. I'll entertain any serious offers. The thing does 60 mph so long as it doesn't start violently rocking back and forth on the checker.
If it doesn't sell soon, I'll part it out (and I'd feel really bad doing that), but I'll be keeping my pinion if I do that.
Ok, next on my Extreme Xmod parts for sale, I have a replica of Jshwaa's 4 li-ion EP built by him. 3X2 motor stack and 2X2 on steering of 7389s, and the reg mounted on the hood. It also includes a drilled chassis for li-ions.
100 w/o shipping, obo FOR THE EP, NOT THE BRUSHLESS XMOD. I ordered an RC18T and will be wedging a Mamba 8000 in that sick little puppy, and I feel I'm too noobish still to handle this Xmod's power.