Yesterday I received a pack from QFM that had motors, batteries, gear sets, springs and other bits stuff.
So I said its time for me tor try the new stabilizers.
When I put a stabilizer (either the one with the 4 holes or the other) my bit goes to the left instead of going straight.
Does anyone knows why that happened?
And the other problem is when I tried the springs from QFM the result was that the magnet and the magnet's spring tension weren't enough for the Bit steering.
Do I need stronger magnets (rare earth) and stronger magnet's spring (?) or should I short the suspension springs a little?
-Thanks
__________________
Nissan Gloria 2.6 + LightMod + 120mAH Cell -- Honda S2000 Silver 3.0 -- Nissan Fairlady Z 3.0 -- Toyota Supra Silver 3.0 -- Mach 5 3.8 -- Ultra Patrol 3.0 -- Ultra Cosmo 2.2 -- Auto Modellista 2.2 -- Bir Racer TRAX Green 2.6 -- DigiQ Subaru Impreza -- Ferrari Set -- LXX -- AudiTT SE ZipZaps -- Mazda RX-8 XMen ZipZaps
Yes, you are right.
I did that just a while a go and its better.
Also by having that problem I found that one of the two front wheels its about half mm higher than the other.
So probably thats the explanation of why it went left.
Thanks
__________________
Nissan Gloria 2.6 + LightMod + 120mAH Cell -- Honda S2000 Silver 3.0 -- Nissan Fairlady Z 3.0 -- Toyota Supra Silver 3.0 -- Mach 5 3.8 -- Ultra Patrol 3.0 -- Ultra Cosmo 2.2 -- Auto Modellista 2.2 -- Bir Racer TRAX Green 2.6 -- DigiQ Subaru Impreza -- Ferrari Set -- LXX -- AudiTT SE ZipZaps -- Mazda RX-8 XMen ZipZaps