Quote:
TuNeR1989
Looking good but why are you using li-ons these will no doubt not have a discharge rate that can withstand a brushless motors needs?
|
I was going to run 3 li-ions at first space got limited with the smaller pinion so now Im using 2. Run time was short but if I get 4 Ill be ok. Ive been thinking li-polys but I dont know if I want to go there yet.
The motor doesnt pull that much current max its 16amps but Im going to do my own test soon to see whats actually going on so I can feed it the power it needs.
Quote:
cdog4w
viperdout did his mamba xmod and he said it tore up bevel gears like no mans business
|
Yeah thats what he said, but I never had a problem with the gears if they properly mesh right he shouldnt have any problems. Well I take that back my first motor upgrade 180 team orion 16t pinion/blue bevel that pinion made its own teeth print in the bevel after that I never had a problem
.
Quote:
5upraAwsome dude, cant wait to start my brushless project! Question...how much room is left when motor is mounted between it and the drive shaft?
|
With a 16t pinion around 2.40mm or .094in. Good luck with your project, take your time and itll come out as smooth as you want it to be.