Is it possible to rewire a bit char-g to run dual motors with differential steering, like in digi-qs? Dual motors by itself isn't difficult; you just need to wire two in parallel. But how can steering be added in to slow down the L and R motors using the L and R output from the PCB? I suspect the digi-q uses a different style PCB with 2 speed controllers, but if it is the same PCB as found on
www.tapspring.com, it would be as simple as finding a diagram of how the digi-q is wired. Does anyone know if this mod is possible? Thank you.
-M.
Digi-q style dual motors with Bit PCB?
Threaded Mode
