|
thinking of getting a microsizer...howz the range???
Well last night i did a PCB swap with a bullet clone PCB and a Tomy bit chassis. Things were looking up, but the real road test prooved wrong. It seams as though the new bullet PCB isn't giving full power to the motor causing it to run slower. Not only that, but it isn't turning to sharp either. Well i've decided that i might as well get a Microsizer, but before i go and get one i was wondering how good the range is on it. I was alos wondering if it is possible to do a telescoping antenna mod to increase range (it should be able to because microsizer controller and TOmy controllers have the same layout right?) anyways, any help wouild be appreciated thanks!!!
|
Threaded Mode
