SE: POST YOUR CUSTOM WISHES! (small shops take notice)

[potentiality]

This thread is to let any small custom cad shops get an idea of what to sell is so inclined.

In order of importance

1. A fiberglass composite chassis with adjustable tab mounts, and lowered motor mount (lower center of gravity).

2. A aluminum or composite steering rod/gear to replace the plastic one (which "bends" during suspension travel). Also is curved slightly on the back near the knuckles to allow greater turning.

3. Easy access to the yokomo maru diff assembly/kit. (I thought I heard these could work on bits/zz).

4. Composite precise steering knuckles that increase the suspension travel/allows use of bit springs.

5. "Snap on" shims for rear axle alignment/play reduction.




Out of these:
1. would be a godsend. I would pay up to $20 for something like that.

2. Very important! I would say up to $6.00

3. Again, I though I read these are compatible, but finding yokomo parts is hard enough, without trying to find all the different part numbers needed to get the rear end (plus the new idler gear).

4. Very nice to have, but not as needed. $6 with new springs. Or $4.60 it is was just a better composite replacement.

5. Just an idea. Not too important, but it can help make the car a bit more precise/reduce gear wear. $2.00 for set.


On a separate wish that doesn't deal with a shop:
Someone to figure out and post the correct fet installation!