Looking for Lab Rats.

[ripper7777777]

Okay at the other place we have been discussing the steering problems, Outcast came up with an experimental mod for fixing the steering, both stuttering and the lack of steps in the propo, but I need more help perfecting it, and I know this board has alot of electronic people on it. I don't know much about electronics, so I don't know why it works but it seems to.

Okay first off there are two differnet cars, a two wire pot and a three wire pot, the two wire pot seems to be limited to the white bricks only, but the three wire pots seem to be in either. On the three wire pots there is a wire bridging the middle wire and the right wire, what we did was remove the bridge and then remove the flat gear, then center the pot and adjust the trim till we have 7 steps in either direction, then put the flat gear back in the center.

Now the questions are why is the bridge there, why does this work, why does the steering become extremely sensitive, and why does it throw off the steering re-centering in some cars.

So lab rats are needed I have a car that I have done this to with good results also I notched the flat gear o get full steering, only problem is a slight bit of wandering, but I'm not sure if it's the car or the overly sensitive controller. So if you have a car about to go back, give it a try and post your results.