Aruuugh....

Dratheus · #1 11-23-2002, 07:00 PM

Alright peeps.....
I'm havin a bit o' trouble with my bit. (and a bit clone) In fact...THEY'VE GOT THE SAME PROB.!!! They both veer right! (I'll cover the obvious) While pressing forward, they veer right, backward....they veer right, PRESSING left while going forward....kinda straight...not much left, pressing right while going forward.....EXTREME right turn. Now for my Fixes. It's not the white trim adjust on the bottom, I've already tried it (correctly). It's not the steering mag., (The bit has a rare-earth mag. and it's centered). My tires do get a bit dirty on the floor, but not 10 sec. after I put the mug down! There are a few hairs wrapped around the pins in the front wheels, but the wheels are still spinning freely. Now...I test the turn commands and they tend to work 90% of the time. Is there anything else I could try OTHER than resoldering the turn wires to the PCB???

Dratheus · #2 11-24-2002, 02:06 AM

WOW!!!

30 some views thus far but no replys????

Any takers?? lol

Dratheus · #3 11-24-2002, 12:08 PM

Anybody up to the challenge???

#4 11-24-2002, 12:25 PM

well i had the same turning problem with my micro-Q clone when i accidently ran off my table and it hit the floor hard. It would steer good only one way. well i whacked it a time or two on the table (not hard enough to break anything) and bingo that fixed it, i'm guessing something is just a bit loose inside. Couldnt hurt to try it. thats all i can thing of, hope it helps.

Dratheus · #5 11-24-2002, 01:06 PM

Whacking it on the table?????? hahahahahahahahahahaha
Well.....maybe I'll try it with the clone to see if it works first. I'd hate to smash my bit char-g already!!!