Forgive me.....................

[Bleek]

I (BC EDIT: WORD REMOVED) hate this its pissing me off so bad............

all i wanted to do was make my own motor
i had the damn SBP motor, i took off the cap and everything form a stage 2 and soldered it on to the SBP, all that was left was the pinion to get on.......

1) tried to yank it off a s2 motor
2)tried to heat it and pull it off
3)bought a damned ninco pull and press that didn't work at all infact broke in my fukin hands (wut a damn waste)

now i don;t know wut the hell others did who did the SBp mod but holy . as a metter of a fact that damned pinion is still on the motor in fromt of me just sitting there pissing me off.

Again........forgive me

now i will prob get kicked off the forum for this but i had to get that off my chest


BC EDIT: Please watch the language! If you coninue to use bad words, you will be banned from the site.

[R33E8]

I feel your pain . Same thing with me .

[slugbugg]

yes those little pinions are very hard to remove thats why you have to use a pinion puller or just buy some replacement pinions to use.

[Bleek]

where can i get replacement pinions!!!!!!?????????????????

[aperson]

you could try plastic pinions from other RC's

[slugbugg]

I havnt verified this but I have read that the pinion gear pitch is 48 and I know the motor shaft is 2mm.
So most slot car hobby shops would have something.

[nrsjs]

I can't help, just wanted to let you know that I feel your pain, I ruined my PN s02 racing motor trying to do a magnet swap a week or so ago

[wasuri]

I ruined stage 2 motor, spinbrush motor, and a stage 1 motor. All for a crap 180 motor that was no faster than my broken stage 1.

i just took a plastic 8 tooth pinion from another RC

[geofroley]

Plastic pinions arent the best choice. Creates more friction.

[aperson]

i got mine from a K'NEX dragster that broke on me.