I need help again

[93civicdx]

i am about to do the dual battery mod. And i was looking under my pcb board when i noticed i snapped one of the copper wires. I can solder it no prob. But i can't figure out where it goes. And one more question when you do the dual battery mod after you solder the end of the battery do you just stick the batterys in the stock tabs or will i have to file the solder down to get it to fit. thanks

[Bunta]

Yo Civic!

The hair thin steering wires connect like this,,

1 goes to the terminal marked (L)
1 goes to the terminal marked (R)
2 to the same terminal your batt + terminal wire connects to

I think you can see in this pic,,, (it's a Tomy PCB)

-Bunta out

[93civicdx]

Thanks i really needed that info