View Single Post
  #31  
Old 10-12-2009, 02:50 AM
fraz fraz is offline
Registered User
 
Join Date: Jan 2003
Location: Santa Cruz, CA
Posts: 118
Quote:
Originally Posted by NanoTrax View Post
also, the RIGHT rear alum. hub needs to be attached just off the bearing to prevent it from restricting rotation (perhaps a shim would work but not sure what to use).
I block sanded the backside of my left aluminum hub with 600 grit. Then had to carefully deburr it and doing so will keep it from bottoming out on the e-clip. The plastic and aluminum hubs are quite different and it appears the Atomic diff was designed around the stock plastic part.

Still would like to know how you got it to work so well. The gear teeth are a different pitch and/or profile from what I have seen.
Reply With Quote