[killer]

:ö: instead of a set-up like this:

SCB top ____2.2k____*____2.2k___
SCB center__________*__________)
SCB bottom_________*____2.2k___)

you can use this set-up with the same result:

SCBtop*_______5.4k or 5.8k_____
SCBcenter*___________________)
SCBbottom*____________2.2k___)

where in:

¤ SCB = Servo circuit board
¤ * = points where you solder your resistor
¤ 2.2k, 5.4k, 5.8k = value of your resistor to be used
¤
-æ