|
I would use a motor with lot's of torque and low top end. I'm assuming it's a technical track, so R-spec may be too fast for "staying within the lines" on the track. You could do a SS wheel mod like me. I put the small front wheels on a blue gear axle for ultimate torque and then use a 2.8-3.0 motor. Not too much top end, but very torque'y.
I did a FS wheel mod on my bB. I used Zap wheels and knuckles actually, so now all tires are big. I use a blue rear axle and a clone motor, and from a dead stop at the base of the hill, I can go up a 45 degree angle. No Problem.
You'll figure it out. If you don't boost your torque, make a lesser angle and longer incline.
|