[Clint]

i put a red zz motor in my 350z bit booster today and for a second i thought my booster was broken.

There is no speed change when u hit boost when using
a red zz motor in a bit booster (mines a 350Z). the only difference is seen on standing starts. has anyone ever noticed this before?

possible reason. unboosted, the bit still can provide enough
current/voltage to allow the red zz motor to run at full speed. hitting boost just gives it more initial starting tq(current).

i wanted to get readings badly, but my multimeter needs a new battery. so for now it's all seat of the pants drag testing. lol

i did some additional testing: all on a single cell 160mA 350z bit booster, blue gears, sticky wide clone tires:

I then swapped in a pink 3.8 into the booster car.
unboosted is very slow. ick
boosted is fast, but takes a little to accelerate.

perfection 3.8:
unboosted is about the same speed as a 2.2 boosted.
boosted, gets up to speed quickly and flips on most corners. blue gears, sticky clone tires.

red zz motor:
almost the same speed as the boosted perfection 3.8, but even more hellacious tq. works very well with aqua gears.


***
the killer test. i put the red zz motor in the tri cell bitzap..OMG it's faster than my 3 cell 1/43 viper.

it beats the viper in a 10 foot drag on both kitchen floor and carpet. kitchen floor took a few attempts..both
cars just like to spin in circles..had to mop the floor first and start both cars on a thin peice of balsa wood..lol

i must have gained a mph or two over the clone motor i was previously using in the tricell. and it's MUCH faster tq and top speed than a perfection 3.8.

i'll need to test out tiny's Formula 3.4
(i assume the r-spec is similar to a perfection 3.8)

fyi..the red zz motor was well used in my original zz.
it squeels like a pig on the tricell.