|
kind of obvious
If ther is a lip on the wheel, trim it off. It may just be casting flash from the manufacturing process. Use an xacto knife and carfully trim it off.
If the hole in the wheel is the wrong size, find a drill bit and use it to enlarge the hole to the outside diameter of the bearing. You do want to be extremly carefull so that the drill is straight and parallel- use a drill press, if you have axcess to one. The axle should hold the bearings in the wheel if it's a little loose. Just remember the point of bearings is to let the bearing take care of all the rotation.
__________________
"If the floor isn't spiffy clean, you may need to get your broom on."
Uhh, gee thanks Radio Shack.
Famous last words:
Hold my beer and watch this
|