[midget_man1387]

I'm sure that somewhere out there, there is a thread on people's techniques for putting their exhausts on, but, whatever. I know that there is a gallery for them, but many people just post pix of their exhausts and do not explain them, so here is a place where everyone can say how they put their exhausts on, and what materials they used. Here is how I did mine:

First, I took a pen tip out of a pen with plyers. the hole (non-pointy side) was about 1-1.25 mm wide. I then took a needle and removed the ink that was in the hole. What I did was stick the needle in the tip, and pull it out, with the ink on it. I would then wipe the ink off on the needle with a wet wad of toilet paper. I repeated this process about 3 times, then wiped the ink off the outside of the tip, and I put it on the chassis of the car. It was very easy to do!