|
Hopefullly that will be it, just swapping the POT's to the correct values *SHOULD* do the trick.
I'm currently working on the maths involved to get some proper vaules. I've selected a 5K linear POT to use at the moment because they are widely available. I've pulled apart my old quickshot joystick and found that the X/Y axis POT's were 150K. This sux because there is too much potential (voltage across the resistor) drop which can be balanced by increasing the ohms of the other two resistors each side of the POT. Too high a resistance will create a very small current, possibly not enough to power the Comparator, dunno, not sure............
Hopefully during the next week the design will be finalised, tested and I should have some video to show the darn thing in action, hopefully!
|