|
It's not that hard to do really. Only takes like 10 minutes to assemble and a bit more for the glue to dry. All you have to do is get a precision screwdriver and hammer the nail out that keeps the wheel in the knuckle in your extra front wheels. From there take your back axle that you will mod and take the rims off. Easiest way to do this is to get a sturdy electric fan. Put the rim attached to the gear in between the bars of the fan. Make sure only the wheel is caught in the bars and pull. Comes out very easily. The other rim is harder to pull of. What I do is take some cutters and cut off the spacer of the rim. It's not a bad thing to cut it off because you would have to cut it off anyways if you wanted to raise your car. Once you cut the spacer off, it's a lot easier to take off. Get the smaller rims that you hammered out and glue them on to the axles. Use another normal back axle to measure correctly. Since the small wheels don't have a spacer, get a small but and slide it on. Put the other rim on. Make sure the nut doesn't have glue on it. Now you have a lowered car. If you want it even lower, take out the suspension bar in front.
|