|
Jay, what are you talking about? The turret motor was most likely soldered to the two points labeled HM- and HM+ on the circuit board in the tank. The red wire is attached to the + and the black to the -. The direction that the motor turns depends on the direction of the current in the circiut. The third and fourth shoulder buttons were apparently the buttons that controlled the turret. If you pushed the left button the turret would turn left. If you pushed the right button the direction of the current would reverse and the turret would turn right. I would not be surprised if the ability to utilize the turret were still there but what needs to be done is to take out 2 shoulder buttons from a second controller and solder them to the empty points on the controllers circuit board(upper left in the picture in this thread). The thing that bothers me though is that I could only find two solder points on the controllers board.
|