[Sniper596]

I have a bullet clone and a microsizer. I must say though the bullet beats the crap out of the microsizer when it comes to speed, at least double. Unfortunately i couldn't run the tomy motor 2.2 in it to see the difference, it just wouldn't work. And the clone motor wouldn't fit into my microsizer. My conclusion for the major differences in speed are the gear mesh, the clone has a very loose gear mesh but the microsizer's is much more tighter, even when lubricated my microsizer cannot catch up.

The car can't steer for beens, because it's too fast and the steering parts are lousy. and the steering doesn't center sometimes meaning a very hard time drive soemtimes

The wheels might be the thing i hate about this clone because they are so poor in quality, not even painted fully and the axel isn't properly centered.

The tires and body may be the best thing about the clone, tires are extremely sticky, and the body is like a real rx7, no real complaints here.

Quality of the chassis and misc parts is alot lower, the anntenna can't even fit into the special slot on the clear cover because its so thick. The plastic seems cheaper and nothing seems to fit right other than the drivetrain.

All in all the bullet is a pretty good deal, half the cost of a microsizer yet fast, if only the quality was better i would be driving it more, oh well at least they make good bits to jump off stuff.