[Stridex]

Here's the first pic

It's hard to see and I appologize. I even tried holding it up to the light. What I was hoping to point out in this pic is how I mounted a plastic piece and melted three copper slivers into them. I then soldered the turning threads to them. The middle was for both positives and left and right are of course for left and right steering. Then I ran regular wires form the PCB to the proper copper sliver. The plastic piece is glued in place as well. The turning threads are also taped to the bottom of the chassis (on the inside) so they're out of the way and out of harm.