|
Nice findings Ovgron. I wonder how you charge a rechargeable Polyacene battery though..? If it works well (and doesn't explode or anything) please post your results!
I need some help from the electronics people.. there are tons of potentiometers and trimmers out there and I'm not sure what I need. They have ratings like "10k Ohm" and range from 1k to 5M. I guess I need something with a pretty small rating. You'd want a possible range from the batteries between 1 volt and 3.6 volts but anywhere close would work fine. It just needs to have enough max resistance to slow the engine down, and small enough resistance at the min value to let it run at the batteries' full voltage.
I'm learning this as I go, so any help is useful. I may experiment with a leftover trimmer dial from a GBA Afterburner kit. The voltages may be comparable since the GBA runs on 2.4-3.0v. It appears to have "B2K" written on it, but it could be "82K". The dial itself is about the same diameter as the inner rim of a front bit wheel and is quite thin. It'd be an easy fit if the voltage works out right.
|