|
How to easily fit ZZ motors into your Bit
I posted some stuff on this a while ago, bad part was hte pic of it, was not in the same thread. This mode has worked for me, just make sure your contact doesnt snag hte body contact. Even with that to keep in mind, I feel this is far better than bending hte heatsink, taking a soldering iron to the chassis, etc.
Here's my howto on it
http://tinyrc.com/forums/showthread....1907#post21907
Here's the pic (upper left corner from left to right: Bit motor, Modified ZZ motor, unmodified ZZ motor)
http://tinyrc.com/forums/showthread....&threadid=2739
__________________
Xmod White Supra RWD
Body Kit
Stage 2 drag motor
Blue springs rear Yellow front
ball bearings, 1.5 tie rod
Hard tread Tires
NiMH batteries
Grease packed rear ball diff.
Yellow Skyline RWD
Stage 2 Drag motor
Yellow springs all around
4.5 Tie Rod
Soft Tread Tires
|