Use a Dremmel tool to reduce the size of the rear most front knuckle pin. (You can see how far I shaved it down in the picture).
Be careful not to scratch the pin. You only need the pin to protrude a little from the metal steering bar. You can then pop the pin out easily to swivel the front wheel around and get at the axle screw in the back of the front wheel. This mod allows you to continually clean the front knuckle/axle and bearings without disassembling any of the front suspension components.
Less disassembly=less chances of stripping the front suspension screw holes. A worthwhile mod -- I can now clean out the front bearings in less then 5 minutes, since I only have to remove the two wheel screws.