[edhchoe]

For the front, I stuffted some hard foam in the empty space for the front part of the chassis to push against. And I glued on a flat piece of plastic from the parts tree on the bottom to hold the chassis. For the sides, I used parts tree pieces as well. I sanded down the parts tree pieces so that I could have some flat surface to glue on. The rear tires are touching the body in the back so I drummelled out some. I used Gorilla "Impact-Tough" formula because I could not find Loctite Epoxy at my local Target store... I hope it holds.
I took the part off on the front end of the chassis where the stock body hooks on. Impul Z body is a near perfect fit for the Murcielago chassis. I had to grind out the bottom part of the front chrome piece and trim down the four support poles inside the body. Because the side of the Impul Z body near the rear wheels is not parallel to the chassis the parts tree piece won't have enough surface area to be glued on. Cut the part long on one end so that long arm can be glued toward the front fender well. I had to replace the ones in the picture with longer ones.

One of the mirrors is already bent after bumping into the wall few times.