|
Slowly but steadily it goes on ...
After re-building the front axle I have continued with the rear part of the chassis and made a kind of mounting rack for the gearbox/motor unit.
In the pics you see the parts of the front axle. The steering arm on the right axle leg is longer than the other because the wire from the servo should be attached there. The ball bearings are 3 x 1 x 1mm, they are glued in self made brass rims (5mm brass round material with a 3mm drilling) and screwed to the axle leg by M1 screws.
The motor/gearbox will be mounted to the chassis with screws in long holes, to be able to adjust the part exactly in direction and height (by grommets).
|