[frizzen]

Sorry guys, I got sidetracked by the BitPimp Topless Contest, and started building an experimental ZZ-M slipper-clutch rear axle that might unlock even more climbing potential.

- I've dropped the PCB height of this truck several *more* thousandths below stock, so hopefully I'll be able to make the motor able to mesh with the winch input without requiring a "gurney bubble" be added to the stationwagon.
- I think I figured out a way to unlock even *more* steering travel to the side that was slightly lacking.
- The replacement ZZ-M PCB arrived (Many thanks to bitpimp "Clint")

Right now I'm stuck on the pinion to input mesh issue, if the lighting stays with body, then the winch board stays with body, so the winch motor HAS to go with body; So the winch gearbox will have to go with body too. Solves a few issues, but creates others.

Winch 'em if ya got 'em!