I posted these on another site also, but I have been reading this site the longest (thanks to dad
), and if some don't visit other forums here ya go.....
So I have been working on this for a bit. It's a ZZSE, that I could drive on my carpeted floor. I was trying to be as simple as possible allowing for more clearance. I ended up using scrap plastic for front shock mounts, inner a-arm links, and rear axle carrier for the added axle. I used paper clips for the actual a-arms and shock rods. The ends of the arms were the steering links trimmed off of a clone's steering linkage.
I still am working on the steering set-up, so of coarse it is still rough around the edges and needs some finalizing of the current mods. Also the body was painted a couple of years ago and needs to be polished up. But, as a work in progress, I thought I might share these ideas around.
I haven't seen any front suspension set ups like this in my seaches, but although I have only been watching this site for a couple years, I wouldn't think this would be the first?
So ... let me know what ya guys think.
