|
I'm overhauling my antenna rig. Basic issue is that every time I would screw on the antenna, I'd go through a 5 minute period making sure there isn't some short somewhere as well as the fragility of the plastic screws. So I dismantled my antenna housing, which doesn't fit on XMODS to get the #4 screw for it (this is a Dean's whip antenna, not an XMODS one). It came with a grommet, but it wouldn't fit on the deck plate. So basically, I dipped the screw about a 1/4 inch into Plasti-Dip rubber coating as well as one side of the nut. After letting it dry about 6 hours. I masked the deck plate with liquid mask (although this isn't absolutely necessary, as the rubber peels off clean) and dipped the deck plate. Very quickly, I put the screw into the antenna screw hole (which I had to bore out with the largest XMODS drill bit to give some insulation spacing.). After drying, I cut away the rubber with an exacto knife and took that off. I've next got to put the nut on to secure the screw and then dip one more time, but the idea is to insulate the screw from the plate (not sure why it shorts things given my multimeter readings, but it does) while being much sturdier than the plastic and increasing the conductivity between antenna wire (haven't had good luck with 18 gauge superflex here, but I'm giving it one more try in a more controlled situation) and antenna.
|