[N2Deep]

The rims are off Dub City new series. I got mine off from the red mazda rx-7, however there is also the blue and red ones available and they are on the Altezza. Best way to get the wheels out from the original axles is by twisting them loose. Then carefully using the right drill bit size and putting it on a hand held chuck, turn the drill till you go all the way through. This step is for front setup. As for the rears you have to use a drill bit that is just a smaller then the axle you are going to be using. You need to dab a small amount of 5 minute epoxy into the new whole and wipe off any access epoxy should it "bleed" out from the wheel. Make sure you don't drill all the way through the wheels that you are going to be using for the rear sets. To get a "true" spin on all four wheels, you are going to have to get something to spin the wheels and then drill it. Good luck on building yours.