|
i mounted a viper body by cutting an aluminum sheet, folding one end to form a clip, and it is liquid nailed from the middle of the roof (underneath the car for looks) and bends over to the clip area... for the front, since Mini-z front thing where you place the nose of the car on the xmod, is slightly larger than that of the xmods, i put 2 plastic pieces in the left and right sides to fit to size, and center. the length of the rear aluminum clip determines the height of the body.
so far, the audi tt, viper, s2000, 360spider, and z8 bodies fit, as i personally fitted all of them.
the only two i ran into a problem with are the enzo and the rx7 (this one fits, but without battery clips)
__________________
Xmods Skyline:
Champagne Gold paintjob
Mild bodykit w/wild spoiler
CL lights
CF centershaft
locked diff.
2nd stg. drift setup
hard slick rear/soft slick front
hard sus. rear/med sus. front
6 Cell w/IC-3's
FET upgrade
Dremel polished motor heatsink (mass mirror)
Flat black rims/chassis/front and rear plates
only thing i really needed.. and only thing i didnt buy:
AWD kit (out of stock everywhere...)
|