|
Thanks.....My first mod attempt does not go very well.
I swapped the magnet from the SB into my stock Stage1 8T motor. Only the magnet is swapped. I also advanced the timing according to the other thread on this form.
But both acceleration and speed is reduced after the swap.
Is that normal?? I was expecting more torque with the SB magnet and better acceleration.
Anyway I tried to go back to the stock magnet but I managed to broke one brush as well as ripping out a piece of wire from the winding on the comm.....hehe......
Typical nubee mistakes without the needed patience.
Off to Ratshack tomorrow??
Should I get the Stage 1 or 2 kit?? I run in tight space so acceleration is important.
Any comments welcome. Thanks.
|