|
Welp, I just picked up some wire from RadioShack, they just had a variety pack with three guages, 22, 26, and 30. The S2 armatures are wrapped with 30, so I opted to go with the 26 gauge wire(22 would probably be too thick to do much with).
So now I have a 20 turn motor with 26 guage wire and I'm concerned it may draw too much energy for the stock FETs. I don't have a voltage meter or anything to check on my own unfortunately.
So, for all your electronic/motor guru's, do any of you have any estimations on what this motor may draw? Would it be safe to throw in my stock FET'd Xmod?
Motor energy draw thread is locked, it would probably be better off there, but I can't reply now...
|