Following is copied from rcmart.com (easier than me typing it out from my printed instructions). They also have a link to full setup instructions, but apparently that was hacked. No joke, go to the link below, then go to the "Mini-X ESC Calibration" link and you get the page that simply reads "TechTeaM haxoring Or box!" MMM box...
SETUP PROCEDURES:
1. Turn on the transmitter(TX.).
2. Turn on the electronic speed controller(ESC).
3. Press the ESC setup button with provided plastic mini screwdriver (use metal screwdriver will easy damaged to the ESC.) For 2-3 seconds until both red and green light off and release the setup button.
4. Wait until green light off and red light still on, press the TX. throttle stick to full forward position when the red light still on and remain the throttle stick in full forward position and wait until green light on and red light off, press the throttle stick to full backward position until the motor going backward.
5. Release the TX. throttle stick and the whole procedure finished.
http://www.rcmart.com/catalog/produc...oducts_id=2407