[frizzen]

Yeah, depending on what the board could handle, I would either bump up the capacatance on the board; or build up something like a 'boost box' to wire in between the PCB and Motor.

The problem is that either way, you'll be adding weight, so even though you'll have more punch for hole-shots and out of the corners; your top speed will be a little less. So you'll probably want to combine a couple more mods into the car.

With the ZZ SE you have a *sorta* propo throttle, right? So you should be able to rig this thing up so it only dumps the caps when you hit the full throttle setting. Instead of a timer-circuit to slow it down, it's up to you. Roll onto the throttle slowly, you get a clean launch. Jab the throttle, and you get burnouts. Smoothly roll onto it all the way, and you get a clean launch and when you hit the full throttle point, it sorta acts like a nitrous shot.

I don't have an SE yet to try to figure the stuff out on, so without a pcb diagram, I'm not really helpful.