|
Ok I have been working on a homemade chassis and I have been looking at the parts very closely and today I noticed something.
As I was looking at the tierod and front knuckles and just moving it back and forth (AWD diff installed) I noticed the diff was moving back and forth, the axles press on the diff and move it alot, I laughed and thought great one more little problem.
I did not have the center shaft or front pinion gear in there so I could not tell how much it would bind up and at this point it is not important to me.
There is diffenently something off set on the front end that could be scrubbing the steering.(along with the tierod tab hitting the diff)
I will worry about that later I'm to far into making my third chassis version.
Check it out on yours to see if yours is the same.
|