|
The engine will be made of plastic, and will be as detailed as I can make it. Also a question for bit-modders, is there a more secure way to open the hood than rubber bands, because none of my glues (plastic cement, contact cement, CA in varying viscositys) will stick to it without peeling off easily. I know epoxy would probably work, but I wouldn't want to mix up a batch to use just on that, so if I do us it, I will wait until I start on another project. Then again I may just have a removable hood, that would give you a more clear view of the engine. I should be able to start on it this weekend, and I will post updates of any progress I make. Thanks for the comments.
-David
|