TinyRC.com - XMODS, XMOD, Micro Flight, ZipZaps, ZipZaps SE, Bit Char-G, MicroSizers, TTTT, Plantraco Desktop Rover, SuperSlicks, Digi Q, Forums, News, Pictures, Parts, and Shop
Forums, XMODS, XMOD, Micro Flight, ZipZaps, ZipZaps SE, Bit Char-G, MicroSizers, TTTT, Plantraco Desktop Rover, SuperSlicks, Digi Q
XMODS Hop-Ups, XMODS Parts, XMOD Hop-Ups, XMOD Parts, Bit Char-G Hop-Ups, Bit Char-G Parts, MicroSizers Hop-Ups, MicroSizers Parts

Go Back   TinyRC.com > Search Forums

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: Murcielago659
Forum: XMODS Parts and Hop-Ups 03-17-2005, 11:04 PM
Replies: 15
Views: 2,343
Posted By Murcielago659
I've only seen it for $24.99 as well. Typo...

I've only seen it for $24.99 as well. Typo perhaps?
Forum: XMODS 02-26-2005, 03:33 PM
Replies: 2
Views: 1,143
Posted By Murcielago659
Pics?

Pics?
Forum: XMODS 02-21-2005, 11:55 PM
Replies: 65
Views: 7,485
Posted By Murcielago659
Most likely the Firebird is going to be an older...

Most likely the Firebird is going to be an older one, of the same vintage as the '69 Camaro and the '65 Mustang. I believe this is because the last high-performance f-body from Pontiac was called the...
Forum: XMODS 02-21-2005, 11:51 PM
Replies: 3
Views: 1,189
Posted By Murcielago659
The antenna is held on by the same kind of screw...

The antenna is held on by the same kind of screw that holds the front knuckles on. Also, if you get the AWD kit, you get four extra of this type of screw.
Forum: XMODS 02-20-2005, 01:14 AM
Replies: 6
Views: 1,406
Posted By Murcielago659
You can advance the timing on a Stage 2 motor,...

You can advance the timing on a Stage 2 motor, it's just not as easy if you have a tuneable motor. You can take the endbell off and use your fingers or a set of pliers to gently turn the commutator...
Forum: XMODS 02-15-2005, 11:54 PM
Replies: 23
Views: 2,270
Posted By Murcielago659
I have 2 that I bought new, and 3 others that I...

I have 2 that I bought new, and 3 others that I got cheap because they were returned as defective. One of them needed a new mainboard, which made up for the cost difference, and the other two were...
Forum: XMODS Mods and Projects 02-13-2005, 02:06 PM
Replies: 5
Views: 1,542
Posted By Murcielago659
Li-Ion = Expensive, lightweight, and can handle...

Li-Ion = Expensive, lightweight, and can handle higher current draw
6-cell = Cheap, but heavy.

In the end, they're both probably very similar as far as top speed goes, but you will notice the...
Forum: XMODS 02-13-2005, 02:03 PM
Replies: 65
Views: 7,485
Posted By Murcielago659
I'm not sure about this. AFAIK, HPI only sells...

I'm not sure about this. AFAIK, HPI only sells them in japan, just like Radio Shack only sells them here.
Forum: XMODS 02-13-2005, 12:14 AM
Replies: 2
Views: 709
Posted By Murcielago659
That was a decent video. Now you need to take it...

That was a decent video. Now you need to take it to the next level. Set up a course on that nice big smooth area you have there (I've said before, paper plates work well), and drift that.

If you...
Forum: XMODS Mods and Projects 02-12-2005, 03:01 AM
Replies: 1
Views: 620
Posted By Murcielago659
I don't know if anyone here actually uses a tire...

I don't know if anyone here actually uses a tire truer. You might try asking over at www.one18th.com in their Tiny RC forum.
Forum: XMODS Parts and Hop-Ups 02-12-2005, 02:56 AM
Replies: 23
Views: 3,460
Posted By Murcielago659
Where did you get this info? I have a 180 motor...

Where did you get this info? I have a 180 motor in my Mustang with the inline resistors, and it works fine.
Forum: XMODS 02-10-2005, 11:40 PM
Replies: 7
Views: 822
Posted By Murcielago659
Good luck with that.

Good luck with that.
Forum: XMODS Parts and Hop-Ups 02-10-2005, 01:21 AM
Replies: 23
Views: 3,460
Posted By Murcielago659
Uh, you should cancel that order IMMEDIATELY. The...

Uh, you should cancel that order IMMEDIATELY. The 3.3kohm resistors are ONLY if you solder them inline with the servo and the original resistors still on the board. You need 4.7kohm SMDs to get the...
Forum: XMODS Parts and Hop-Ups 02-08-2005, 08:44 PM
Replies: 11
Views: 1,773
Posted By Murcielago659
At this point, you should seriously look into a...

At this point, you should seriously look into a better motor than the stage 2. The NML Stage 11 is a good choice, and will match your battery setup well.

EDIT: I just realized you're using the '04...
Forum: XMODS 02-08-2005, 08:42 PM
Replies: 17
Views: 2,826
Posted By Murcielago659
Good list, Horshu, but you should put the...

Good list, Horshu, but you should put the steering resistor mod under the "Good-to-haves" list.
Forum: XMODS 02-08-2005, 08:38 PM
Replies: 5
Views: 2,012
Posted By Murcielago659
That's an OK vid. To really drift, you should set...

That's an OK vid. To really drift, you should set up a few cones (paper plates work well) and try to slide around them in a controlled fashion. All I see in your vid is random steering/throttle...
Forum: XMODS Parts and Hop-Ups 02-08-2005, 03:07 PM
Replies: 11
Views: 1,773
Posted By Murcielago659
Are you using the blue motor? Try switching to...

Are you using the blue motor? Try switching to the red or white motor. It sounds to me like you're trying to put too much current thru them. Beyond that, try getting a 180 or something like that....
Forum: XMODS 02-08-2005, 03:05 PM
Replies: 17
Views: 2,421
Posted By Murcielago659
Oh, I totally spaced that. Try putting the...

Oh, I totally spaced that. Try putting the battery holders in a different spot. The way I did it was I left them unscrewed, and then put the body on, and moved the holders until it fit perfectly....
Forum: XMODS 02-08-2005, 03:02 PM
Replies: 17
Views: 2,826
Posted By Murcielago659
I didn't have to trim my steering knuckles...

I didn't have to trim my steering knuckles...
Forum: XMODS Mods and Projects 02-08-2005, 01:33 AM
Replies: 2
Views: 987
Posted By Murcielago659
First of all, click here....

First of all, click here. (http://www.starterupsteve.com/swf/posting.html?
)

Secondly, you will only get longer runtime, and probably less performance due to the added weight.
Forum: XMODS 02-08-2005, 01:27 AM
Replies: 17
Views: 2,826
Posted By Murcielago659
I've done the steering resistor mod on all of my...

I've done the steering resistor mod on all of my XMods, except I used a 2.7kohm resistor. With these resistors, the servo stops right at the plastic stop on the servo case. I'm sure the 3.3kohms are...
Forum: XMODS 02-07-2005, 08:54 AM
Replies: 3
Views: 620
Posted By Murcielago659
You most likely put the wheel lugs on too tight....

You most likely put the wheel lugs on too tight. This is a common mistake, so don't feel too bad if it's the problem.
Forum: XMODS Parts and Hop-Ups 02-06-2005, 05:34 PM
Replies: 26
Views: 4,595
Posted By Murcielago659
In Japan, the RSX is still called the Integra....

In Japan, the RSX is still called the Integra. It's the same car we get here already.
Forum: XMODS Mods and Projects 02-05-2005, 11:00 PM
Replies: 12
Views: 1,422
Posted By Murcielago659
The battery was probably bad anyway. If it would...

The battery was probably bad anyway. If it would only hold a charge for 30-45 minutes in a phone that has no moving parts, it would probably only last about 2 minutes in an XMod.
Forum: XMODS Mods and Projects 02-05-2005, 10:56 PM
Replies: 51
Views: 11,274
Posted By Murcielago659
I'm not complaining about the weight of your car....

I'm not complaining about the weight of your car. I understand that the gain will be minimal. I was merely pointing out that he asked a very obvious question that deserved a very obvious answer.
...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:23 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Mini Inferno Sale - Up to $85 Instant Savings!
Micro-T Hop-Ups
RC18R, M18, Micro RS4, Mini-LST, TamTech-Gear, Minizilla, RC18T, RC18B, RC18MT
shop.tinyrc.com Products
Tiny RC Community News
[03/17/10] Kyosho Mini-Z F1 MF-010 SP2... : The Kyosho Mini-Z F1 MF-010 SP2 Carbon Limited ASF 2.4GHz Tx-Less Chassis Set - more»
[10/23/09] Kyosho Mini-Z MR-03 In Stock! : The Mini-Z MR-03 (http://mr-03.com) is now In Stock and Pre-Orders are shipping! - more»
[09/06/09] Labor Day Savings - $5 Off... : Labor Day traditionally marks the unofficial end of summer - but we're not ready to let go! So, we - more»
Mini-Z, Mini-Z Racer, MR-02, MA-010
M18, M18T, RC18T, Mini-LST, Mini-T, Micro RS4, XRay, 1/18, 18th scale
XMODS, XMOD, Micro Flight, ZipZaps, ZipZaps SE, Bit Char-G, MicroSizers, TTTT, Plantraco Desktop Rover, SuperSlicks, Digi Q
Mini Inferno, Mini Inferno ST, half EIGHT, 1/16, 16th scale
Epoch, Indoor Racer, 1/43, 43rd scale
E-Savage, eSavage, eZilla, e-Zilla, HPI
Robots, Bots, Bipeds, Wheeled, Manoi, Roomba, NXT, Lego, Hacking
Crawling, Crawlers, Micro, RC, Losi Mini-Rock Crawler, Duratrax Cliff Climber
Kyosho Minium, Caliber 120, Minium Forums
Mini-Z Hop-Ups, Mini-Z Parts, Mini Inferno Hop-Ups, Mini Inferno Parts, M18 Hop-Ups, M18 Parts