Really wide turns on my clone
 

, I have a "R/C Chassis" bit clone and it seems to turn really wide, at first it would turn sharp to the right but wide to the left, I openend up the front and cleaned it all out(there was metal shavings in there!) and this helped a bit, I then took a dead Shen that I had and transplanted the front spindles and such, it at leas now is equal but turnd very wide, nothing seem to be rubbing, any ideas on what would cause this? should I make up some new coils for the front ?could this be the cause?the only parts that are not from the shen is the stabilizer and top cove of the steering.

I have a similar problem with my microsizer- it turns sharp to one side, but extremely wide to the other. Any suggestions?

put another battery in it

you will have crisper steering and your car will be a heck of a lot faster.

so going to dual cell would be the only option other than buying a bit?;)

Well from what I have seen, some clone chassis just have crap steering.
(Mind that I am pretty new to bit modding)

Now as for the MicroSizer with wide one way sharp another, I would suggest popping the steering stuff open, your magnet is probably offset, needs to be centered.

YMMV

ok ill try that stuff later... thx

...make a new steerin spring!.. look 4 a thread called ITS TWISTED...i used 2 strands of speaker wire twisted together...