How good is the Perfection 3.8????
 

Anybody have the perfection 3.8 from toyeast? I saw a post on it and had to order one w/my Gloria set. I couldn't pass it up since w/the Gloria set the motor was under $3 US. I have a bitmod1 3.5 and am waiting for my replacement R-spec, so I will do my own comparisons once it arrives. If you have one, have you tested it againtst any other motors? All info is greatly appreciated.:D

3.8
 

WORKS GREAT, BUT YOU WILL NEED TO LUBE THE SHAFT MORE THAN LIKELY. If it seems slow, then lube and clean off any excess.

starion_999,
What setup are you running the perfection in? Also, what did you lube it with?:confused:

perfection set!
 

it works great. lots of torque. 160mah batt holds the power well.
im sold on the perfection motor. although i dont have a dks v2, the 3.8 perfection is my motor of choice.

i have it running in my fairlady and it rocks i have the original 3.4 from dks witch has always been my moter of choice untill now. the perfection is awsome.

...where did you find this perf.3.8? im an addict and i NEEEED this motor!...

slowbutcurious, you can find this motor at toyeast under the bit char-g parts section

I got A 3.8 and it's from a clone and it is as fast as a normal 3.8.b38:D

what clone has a 3.8

Can't they just ship it in a strong envolope to save on shipping. I really don't want to pay $5 shipping for a $5 motor.

3.8's are better in every way than a 3.0. People who think that 3.8 takes forever to get to top speed are wrong. It has tons more torque than a 3.0. 3.0's have so little torque that it's even hard to get it started with a dual cell.