A question on pcb wiring
 

Hey there,

I kinda brok my steering wires when doing the dual battery mod. I found that i broke 2 wires. One of them supposed to be connected to the right steering, and the other one, im not sure...
I looked at a lot of pics for the pcb wiring and i think it goes to the red wire. the red wire has a copper one on it too. Any suggestions?:confused:
Thanks for readin!:D

HOLY CRAP
 

DUDEEEEEE WIERD!!!!!!!!!!! same exact thing happened to me today i was putting in my dual battery mod and then noticed that it would only steer to the left so i opened it up and sure enough two of my wires were not attached so what i did was soldered one of the wires to the places your said and it works fine now that is odd how that happened to us on the same day

heheh, weird. Mine still isnt, i dont know which wires to solder where. Im thinkin the one painted white goes to where the red wire goes to ,and the other uncolored one goes into the right steering spot. Am i right? I dont want to mess up my bit up some more.

hum didly dum... Anyone? (not to be spammish..):confused: :confused:

Maybe this will help.
In the picture:
V+ --- Red Wire
F --- Blue Wire
B --- White Wire
GND --- Black Wire

Also:
You will have four tiny enameled wires. Two have black paint on them. Those two are soldered to V+. The other two go from their respective coils to either L for Left or R for Right. You may have to use a little fine sandpaper to remove the enamel from the wires before you solder them.

I hope that's what you were looking for.

http://tinyrc.com/qfm/racing/dls/pcbguide.jpg