tomy bit char-g built to last!!
 

ok i just wanted to tell you guys my horror story!!

I was walking down my stairs with the tomy bit char-g charging on the controller ...i take one step down and all i hear is "plop" i look at my controller and i see my car go flying off!! i screamed in fear!!! it tumbled down another two steps then straight down to my ceramic tiled floor!!! i saw the lid go flying and i thought to myself...damn my poor car is a gonner!! i rushed downstairs and looked at it..the pcb was half hanging out and i was in shock!! i put everything together hoping for a miracle....and guess what...

my car is still good!! well one of the lil clip on the pcb cover broke off...but that's it..the steering was fine and the car drive as fast as it always have with my 3.0 motor.

well the moral of this story is ...TOMY BIT CHAR-G ARE BUILT TO LAST!! ... and also, never walk while charging ur bit char-g..heh


ok that's it

bye

LIKE A ROCK.......oooooooo.....like a rock......ooo wait...wrong commercial.....heheheheh

Finally learned about the truth of charging your Bit will moving around eh. Whenver I have to charge my Bit on the go, I wrap duct tape around it and the controller to secure it. When I'm done, the only drawback is the adhesive stuff that remains on both the controller and the car.

J/K

umm....my tabs that hold the car on place broke off my controller charger..;/
so i HAVE to hold it down..very annoying...

Make a replacement. Just file down plastic to the right size and use some sort industrial strength plastic super glue. I used it on my replacement chassis tabs and they can take a lot of pressure.

one problem...i cant find the tab..haha...gone..
for the moment, i use a FAT rubber band that is normally used on brocolli :D..works good at the moment...i just wrap it around the controllerr and the car....and wait....

I did not mean glue the tab back, but rather make a new plastic piece as a replacement part and glue it onto the charger. I wouldn't expect someone to keep such a small piece of plastic anyways. I cant seem to find my ruler to take down the measurements for you.

thats ok...ill figure it out somehow...
ill probably swap the plastic charger piece from my dead ZZ
...ill just have to take out that little holder tab...

dookie..how about some pictures of your mod

My lowered chassis tab mod?

Ok.

http://www.imagestation.com/album/?id=4291237285

I have to join....does it cost anything Dook?

Hahahaha, someone here finally called me dook. I get called dook a lot in counter strike hahah!

It doesn't cost you anything to make an account on imagestation. I tried to find some information on the total space they give for your pictures but all I found was that they limit the lenght of your videos to like 15 minutes.

hehe
 

Yeah they are built to last today i bet you my bit took 30+ falls at school :) It runs PERFECT still :)