Beyond Awesome Fully Proportional
 

Fully proportional ZZMT, courtesy of Iwaver some cheesey cheap micro car, a Futaba S3003 servo, and a couple of E-TEC lithium-poly cells.

http://lbspd.com/v-web/gallery/album.../zzm.thumb.jpg

http://lbspd.com/v-web/gallery/album...Modded_ZZM.jpg

http://lbspd.com/v-web/gallery/album...tional_ZZM.jpg

You MUST get some video on that thing in action!!!

Do you think that you coulde show how you riged the servo. I'm going to install my se parts into my truck but need to know how to modify the stock steering to be fully praportional.

dude a step by step guide would be mad sweet!!! I have a ton of leftover electronics laying around for something like that.

Hey lbrc can you please tell me how did you make this thing steer with the stock steering system and the iwaver cb???
Did you use a 3,3 kohm resistor at the left outputs???
And what's this near the steer-motor???
Is it to drow the volts that go to the steer-motor???
I 'm running on 3cell what do you believe i'm gonna need to make it steer with the stock steering system and the iwaver cb??
Anyone who can help please answer to this thread or mail me at snakeman@in.gr :(

http://lbspd.com/v-web/gallery/album...tional_ZZM.jpg

What did you do with the S3003?

I waver should have provided all parts neccesary I'd assume.

First of all are you talking to me or to LBRC???
Well however i don't know what the S3003 is.
My cb is from an iw 01.
And i Finally made it know my ZZ MT is working properly.
I soldered a 3.3Kohm resistor to the right front outputs and a stronger motor(from the stock steering motor) to the left front outputs and now run just perfect.
But i thing that my steering is a bit noisy.
Anyway if you thing i did something wrong please let me know

And here is a nice video of my MT Wheeling.
http://briefcase.pathfinder.gr/downl...EDITION%29.wmv

http://briefcase.pathfinder.gr/downl...82%29Small.jpg

Hi, some videos of the monster?