My new PORSCHE 911 XMOD!
 

Ok, so i was cleaning my room and i found this old porsche model i had made a few years back, i took it apart and it was a perfect fit for the xmod. I took the tires off, switched them with the xmod and now all i need to do is figure out a good way to secure the body to the frame. any ideas?

I really like the way the wheels turned out. larger and wider wheels in the back and slightly smaller ones in the front(just a little larger than the stock ones)

Anyways, what do you think?

sporttracguy

of course the body is sitting a little low because its just resting on the xmod until i can figure out how to secure it

you can see here the width of the rear tires compaired to the front tires. they are sticky for model tires, not quite as sticky as the stock ones but they have better tread

here is a front on shot,, i better not hit anything, dont want to break this pretty face

ok, last picture, you can get a better look at these rims. also in the previous picture, the headlights are clear so i think i may need some headlights

ok, lets see if the picture shows up

that shot nice job, you could always use Velcro.. and keep that body low, espically if its for show!

This is a bit old, but, dont use AWD with those wheels, they are different sizes and it won't run right. Just thought i'd warn you.

i would watch out for your front wheels hitting walls and such

you might strip out a servo gear or two

I was about to write that. Otherwise, very cool man!